JLG X23J - X700AJ Service Manual - Manual (Page 392)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-365
INSTALLATION PROCEDURE
7. If necessary, install adjusting link (2) and install bolts
(5) finger tight.
NOTE: The adjusting link on some engines is secured by
one bolt.
8. For engines that have an adjusting link that is
secured by one bolt, leave bolt (5) loose.
For engines that have an adjusting link that is
secured by two bolts, tighten bolts (5) to a torque of
10 N·m (89 lb in).
9. Position alternator (6) on the engine and install bolt
(7) finger tight.
10. Install bolt (1), washer (3) and nut (4) finger tight.
11. Install the V-Belt. Refer to Disassembly and Assem-
bly, “V-Belts - Remove and Install”.
NOTE: Ensure that the alternator pulley is in alignment with
the crankshaft pulley. Ensure that all fasteners are
tightened.
12. Connect the harness assembly (not shown) to the
alternator.
13. Turn the battery disconnect switch to the ON posi-
tion.
ELECTRIC STARTING MOTOR - REMOVE AND
INSTALL
REMOVAL PROCEDURE
ACCIDENTAL ENGINE STARTING CAN CAUSE INJURY OR DEATH
TO PERSONNEL WORKING ON THE EQUIPMENT. TO AVOID ACCI-
DENTAL ENGINE STARTING, DISCONNECT THE BATTERY CABLE
FROM THE NEGATIVE (−) BATTERY TERMINAL. COMPLETELY
TAPE ALL METAL SURFACES OF THE DISCONNECTED BATTERY
CABLE END IN ORDER TO PREVENT CONTACT WITH OTHER
METAL SURFACES WHICH COULD ACTIVATE THE ENGINE ELEC-
TRICAL SYSTEM. PLACE A DO NOT OPERATE TAG AT THE START/
STOP SWITCH LOCATION TO INFORM PERSONNEL THAT THE
EQUIPMENT IS BEING WORKED ON.
1. Disconnect the battery.
2. Make temporary identification marks on the harness
assemblies that are connected to the electric start-
ing motor.
3. Disconnect the harness assemblies (not shown)
from electric starting motor (2).
4. Remove fasteners (1) that secure electric starting
motor (2).
NOTE: Support the weight of the electric starting motor as
the fasteners are removed.
5. Remove electric starting motor (2) from the engine.