JLG X23J - X700AJ Service Manual - Manual (Page 326)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-299
GENERATOR
General information:
Before dismantling, check operation of the generator
(measure off-load voltage).
Preliminary work:
– Disconnect the battery: negative pole first, positive pole
second.
– Take off the fuel tank with the air guide housing.
– Take off the flywheel and the starter.
Testing / repair:
– Check parts for damage and renew if defective.
Dismantling:
– Take out machine screws 1 with spring washers 2; take
off rotor 3.
– Unscrew the equipment box from the partition panel.
– Remove the partition panel.
– Detach the cable connector at the regulator switch.
– Open the plug and detach the two yellow wires in sock-
ets 3 and 4 using tool - 4 -.
– Pull the generator cable out of the hole in the crankcase.
– Mark the position of the coil in relation to the crankcase
with a scriber, so that it can be centred correctly.
– Take out machine screws 4 with spring washers 5 and
take off coil 6.
Assembly:
– Follow the dismantling procedure in the reverse order.
– Before tightening coil 6, align it so that it is concentric
with the crankshaft (scriber mark).