JLG X23J - X700AJ Service Manual - Manual (Page 546)

SECTION 6 - JLG CONTROL SYSTEM
3121448 – JLG Lift – 6-57
1. Press button 6 "SERVICE"
2. Press button 7 "SET-UP“.
3. Press button 5 “PASSWORD”.
Using the remote control buttons to enter the pass-
word 2857.
NOTE: password above allow to choose machine number
and engine type.
Once the correct password is accepted the display
shown “OK”.
4. Press button 9 “ESC”.
Repeat the above steps if “NO” appear on the dis-
play.
5. Press button 4 “ROTATION” to enter in ROTATION
SETUP.
6. Press Button 1 for RESET .
7. Press 3 times button 9 to Esc to escape.
8. Press button 6 "SERVICE“.
9. Press button 1 INP OUT.
10. Press button 2 “SUCC” until shown “ROTATION”.
11. Check that the value is equal to 360 degrees.
If the value is different from 360 degrees repeat the proce-
dure.