JLG X23J - X700AJ Service Manual - Manual (Page 538)

SECTION 6 - JLG CONTROL SYSTEM
3121448 – JLG Lift – 6-49
To change the working hours of the Engine or Electrical
Motor.
1. Press button 7 “SETUP”.
2. Press button 5 “PASSWORD”.
Using the remote control buttons to enter the pass-
word 7385.
NOTE: password allow to change the Working Hours of
Engine and Electrical Motor.
Once the correct password is accepted the display
shown “OK”.
3. Press button 9 “ESC” two times.
NOTE: Repeat the above steps if “NO” appear on the dis-
play.
4. Press button 6“W:HOURS”.
KEEPING PRESSED the button 6 use the button
1”T+” to increase and button 2”T- “to decrease the
working hours of the ENGINE.
KEEPING PRESSED the button 6 use the button 7”
E +” to increase and button 8 ”E - “to decrease the
working hours of the Electric Motor.
KEEPING PRESSED the button 6 and than button 3
to set zero the working hours of Engine and Motor.
5. Press button 9 ESC 3 times to escape.
On Lithium models the Engine working HOURS will stay
always 0.
The procedure to view or change the working Hours of the
electrical motor are the same as per double powered
models.