JLG X23J - X700AJ Service Manual - Manual (Page 376)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-349
3. Remove bolt (3) and remove adjusting link (2) for the
alternator from water pump (1).
NOTE: On some engines, the adjusting link for the alterna-
tor is secured by two bolts.
4. Remove fasteners (7) and remove water pump (1).
NOTE: If necessary, gently tap the water pump with a soft
faced hammer in order to loosen the water pump.
5. Remove joint (6) from the cylinder head.
If the water pump has a spacer, remove spacer (5), and
remove joint (4).
INSTALLATION PROCEDURE
KEEP ALL PARTS CLEAN FROM CONTAMINANTS. CONTAMI-
NANTS MAY CAUSE RAPID WEAR AND SHORTENED COMPONENT
LIFE.
6. Ensure that the mating surfaces of the water pump
and the cylinder block are clean and free from dam-
age. If the water pump has a spacer, ensure that the
mating surfaces of the spacer are clean and free
from damage.
7. Install a new joint (6) to the cylinder head.
If the water pump has a spacer, install spacer (5)
and install a new joint (4) to the cylinder head.
8. Place water pump (1) in position and install fasten-
ers (7). Tighten the fasteners finger tight.
9. Position adjusting link (2) for the alternator on the
water pump. Install bolt (3) finger tight.