JLG X23J - X700AJ Service Manual - Manual (Page 501)

SECTION 6 - JLG CONTROL SYSTEM
6-12 – JLG Lift – 3121448
Remote Control Operation
On models with Remote Control connected by cable, if
shown the message PREOPERATIN, that means an issue
with CanBus link:
On models with Radio Remote Control shown the mes-
sage of PREOPERATN, can be one of the following rea-
sons:
Just been switched ON
The receiver is off (ignition key OFF)
The receiver needs to be initialize the radio control/remote
control an issue with CanBus link
On models with Remote Control connected by cable, if
shown the message DOWNLOAD, that means a new mod-
ules have been installed.
Display on Radio Remote Control
When the procedure ends the display will show the screen
with the icons.
NOTE: The initialization procedure will be completed faster
if the radio control/remote control cable is con-
nected.
NOTE: The numbers shown above DOWNLOAD are the
data transferred. The Download will be completed
when about more that 18000 steps are transferred.