JLG X23J - X700AJ Service Manual - Manual (Page 190)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-163
CHARGE COIL INSPECTION
10 A / 18 A CHARGE COIL /12 V-15W /12 V-25 W LAMP
COIL TYPE
Disconnect the charge/lamp coil connectors.
Measure the resistance between the terminals of the
charge/lamp coil.
Resistance:
charge coil 10 A:0.16 - 0.24 .
charge coil 18 A:0.10 - 0.30 .
lamp coil 12 V-15 W:1.04 - 1.56 .
lamp coil 12 V-25 W:0.30 - 0.46 .
Check for continuity between each terminal and engine-
ground.There should be no continuity.
•If the measured resistance is not within the range specifi-
cation or if any wire has continuity to engine ground,
replace the charge coil.
•If the resistance is good and the flywheel is ok, replace
the charge coil and retest.
10 A / 18 A CHARGE COIL /12 V-
15W / 12 V-25 W LAMP COIL TYPE:
Inspect between
each terminals.
10 A CHARGE
COILTYPE:
18 A CHARGE COIL /
12 V-15W / 12 V-25 W
LAMP COIL TYPE: