JLG X23J - X700AJ Service Manual - Manual (Page 183)

SECTION 3 - CHASSIS & TURNTABLE
3-156 – JLG Lift – 3121448
CONTROL BASE ASSY. DISASSEMBLY/
ASSEMBLY
MANUAL OPERATION TYPE
Remove the control base assy.
CONTROL LEVER
SCREW (5 x 32 mm)
CONTROL BASE
CABLE RETURN SPRING
INSTALLATION:
Install with the short end of
the spring toward the
control base.
Hook the cable return
spring to the hole of the
control lever.
WIRE HOLDER
(If equipped)
SCREW (4 x 6 mm)
CONTROL LEVER
SPACER
LEVER SPRING
(If equipped)
CONTROL ADJUST
SPRING
ASSEMBLY:
Adjust the maximum
speed.
CIRCLIP (5 mm)
(If equipped)
CLAW
SELF-LOCK NUT (6 mm)
ASSEMBLY:
After tightening the nut fully,
loosen it 1–1/2 turns.
ASSEMBLY:
Note the installation direction.
STOPPER COLLAR
SCREW (5 x 25 mm)
(If equipped)
(If equipped)
(If equipped)
CONTROL LEVER WASHER
WIRE HOLDER
(If equipped)
SCREW (4 x 6 mm)
(If equipped)
CIRCLIP (5 mm)
(If equipped)
ASSEMBLY:
Install the control lever washer by
aligning the cutout of the control
lever washer with the claw of the
control base.