JLG X23J - X700AJ Service Manual - Manual (Page 110)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-83
6. Assemble the nos.2 two speed pistons (M5) into their
seats inside the flanged hub (M2).
BE SURE THAT THE PISTONS CAN MOVE FREELY
INTO THE SEATS.
7. Place the bearing (M8) on the motor shaft (M9).
8. By using a stopper and a rubber hammer push the
bearing (M8) against the motor shaft shoulder (M9).
9. Place the bearing-motor shaft sub-assembly (M8-M9) in
the seat inside the flanged hub (M2).
BE CAREFUL WHEN INSERTING THE SHAFT INSIDE
THE MOTOR SEAL, THAT MUST BE GREASED.
10. By using a plastic hammer push the bearing-motor
shaft unit (M8-M9) against the flanged hub shoulder (M2).