JLG X23J - X700AJ Service Manual - Manual (Page 200)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-173
RECOIL STARTER ASSEMBLY
TO PREVENT SERIOUS EYE INJURY, ALWAYS WEAR SAFETY-
GOGGLES OR OTHER EYE PROTECTION WHEN USING COM-
PRESSED AIR.
Pass the recoil starter rope (1) through the hole (2) of the
recoil starterpulley (3), and then tie the rope as shown.
BEFORE INSTALLING THE RECOIL STARTER ROPE, CHECK FOR
FRAY OR WEAR.
Wind the recoil starter rope onto the recoil starter pulley
counterclockwise.
Hook the outer hook (1) of the starter return spring (2) to
the groove (3) of the recoil starter pulley (4), and then
install the starter return spring by winding it.
Apply grease to the cutout (1) of the recoil starter case (2).
Set the recoil starter pulley (3) to the recoil starter case by
aligning the inner hook (4) of the starter return spring with
the cutout of the recoil starter case.
(3)
(1)
(2)
10 mm
(0.4 in)
(2)
(4)
(1)
(3)
(2)
(3) (1)
(4)