JLG X23J - X700AJ Service Manual User Manual
Page 381
SECTION 3 - CHASSIS & TURNTABLE
3-354
– JLG Lift –
3121448
HOUSING (FRONT) - REMOVE
REMOVAL PROCEDURE
Start By:
a. Remove the fuel injection pump. Refer to Disas-
sembly and Assembly, “Fuel Injection Pump -
Remove”.
b. Remove the crankshaft pulley. Refer to Disas-
sembly and Assembly, “Crankshaft Pulley -
Remove and Install”.
KEEP ALL PARTS CLEAN FROM CONTAMINANTS.CONTAMI-
NANTS MAY CAUSE RAPID WEAR AND SHORTENED COMPONENT
LIFE.
CARE MUST BE TAKEN TO ENSURE THAT FLUIDS ARE CON-
TAINED DURING PERFORMANCE OF INSPECTION, MAINTE-
NANCE, TESTING, ADJUSTING AND REPAIR OF THE PRODUCT.
BE PREPARED TO COLLECT THE FLUID WITH SUITABLE CON-
TAINERS BEFORE OPENING ANY COMPARTMENT OR DISASSEM-
BLING ANY COMPONENT CONTAINING FLUIDS. DISPOSE OF ALL
FLUIDS ACCORDING TO LOCAL REGULATIONS AND MANDATES.
1. If the engine is equipped with a turbocharger, dis-
connect the hose from connection (1).
2. Remove nuts (4) and bolts (9).
3. Remove cover (8) and O-ring seal (7).
4. Remove fasteners (3). Identify the position of the dif-
ferent fasteners for installation.
5. Carefully remove front housing (6) from plate (5).
Ensure that pin (2) remains in the front housing.
NOTE: The front housing is aligned to the plate and to the
cylinder block with dowels.
6. Remove the joint (not shown).