JLG X23J - X700AJ Service Manual - Manual (Page 133)

SECTION 3 - CHASSIS & TURNTABLE
3-106 – JLG Lift – 3121448
TRANSPORTING UNPACKED SLEW DRIVES
Figure 3-183. Use suitable lifting gear/never transport
product vertically
Unpacked slew drives can be transported with lifting gear
when using eye bolts under the following conditions
• The lifting gear must be configured appropriately for
the weight of the transport units.
• The ring bolts must be configured appropriately for the
weight of the transport unit.
• The slew drive shall only be transported by itself, with-
out attached parts.
• Maintain the insertion depth prescribed by the manu-
facturer.
• If insertion depth is not prescribed, then a minimum
insertion depth of 1.5 x the bolt diameter must be
selected.
• Transport within the company shall only be executed
horizontally.
Figure 3-184. Always use the full length of the thread
Attachment:
1. Screw the 3 eye bolts into the 3 threads that are dis-
tributed uniformly on the circumference of the slew
drive.
SCREW IN THE EYE BOLTS TO THE FULL THREAD LENGTH!
IMPROPERLY ATTACHED, UNSUITABLE, OR DAMAGED EYE
BOLTS MAY CAUSE THE SLEW DRIVE TO FALL AND CAUSE LIFE-
THREATENING INJURIES.
2. Attach lifting gear to the eye bolts.
3. Start the transport.