Lenze 931M-931W - Manual (Page 142)

Appendix
Index table
10

142 KHB 13.0003-EN 2.0
Characteristics Possible settings Name Index
Description Selection Lenze
6040
h
0 control word 0000
h
0000
h
{1
h
} FFFF
h VAR
UINT1
6
RW MAP
Changing the controller
status.
Activating an action (e.g.
homing).
Bit No. Meaning
0 Switch on Controlling the status
transitions. (These bits are
evaluated together).
1 Enable voltage
2 Quick stop
3 Enable operation
4 ... 6 Operation-mode specific The bit function depends
on the operating mode.
7 Reset fault With a zero/one
transition, the controller
tries to acknowledge the
existing errors. This is only
successful, when the cause
of the error has been
removed.
8 Stop The bit function depends
on the operating mode.
9 ... 10 Reserve Reserved, set to 0.
11 ... 13 Operation-mode specific The bit function depends
on the operating mode.
14 Wait for sync The bit function depends
on the operating mode.
15 Remote request When this bit is set,
remote control of the
controller via the CAN bus
is requested. When this bit
is not set, local controller
operation (e.g. via the
»fluxx« software) is
enabled.