MacDon FD75 OM User Manual
Page 117
NOTE:
The numbers under this display are simply
reference numbers they do not represent any
particular value.
Figure 4.124: Combine Display
Adjusting the Manual Header Raise/Lower Rate (John Deere 70 Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To adjust the raise/lower rate, follow these steps:
1.
Press button (A), found on the right-hand console,
once. On the Command Center the page displays the
current setting. This is your raise/lower rate setting.
The lower the reading the slow the rate.
2.
To adjust the rate, use scroll knob (B). The adjustment
will be automatically saved.
If the page remains idle for a short period of time it will
return to its previous page or the ENTER button (C)
can be pushed to return to the previous page.
Figure 4.125: Combine Control Console
169894
103
Revision A