MacDon FD75 OM - Manual (Page 198)

OPERATION
Attaching Tow-Bar
The tow-bar consists of two sections which make storage and handling easier.
1. On the RH side of the header, unhook rubber strap (D)
on cradle (A).
2. Remove clevis pin (C). Detach tube end from support
(B).
3. Replace clevis pin.
4. Lift inner half of tow-bar off of header, and place it near
the left side of the header.
Figure 4.281: Removing Tow-Bar
5. At left side of the header, unhook rubber strap (D) on
cradle (A).
6. Remove hitch pin (C) from support (B), and remove
tow-bar.
7. Install rubber strap (D) on cradle (A).
Figure 4.282: Removing Tow-Bar
169894 184 Revision A