MacDon FD75 OM - Manual (Page 393)

MAINTENANCE AND SERVICING
11. Slide tine tube (A) outboard to expose the bushing.
Remove the bushing halves (B). If required remove the
next tine or plastic finger, so that the arm can slide off
the bushing. Refer to:
• Removing Plastic Fingers, page 375
• Removing Steel Tines, page 374
Figure 6.269: Cam End
Installing Bushings on 5-, 6- or 9-Bat Reels
WARNING
To avoid bodily injury from fall of raised reel, always engage reel safety props before going under raised
reel for any reason.
IMPORTANT:
Ensure tine tube is supported at all times to prevent damage to the tube or other components.
Cam End Bushings
1. Position bushing halves (B) on tine tube so that lug in
each bushing half is positioned in hole in tine tube.
2. Slide tine tube (A) inboard to cover the bushing (B). If
any fingers where removed reinstall them at this time.
Refer to:
• Installing Steel Tines, page 374
• Installing Plastic Fingers, page 375
Figure 6.270: Cam End
169894 379 Revision A