MacDon FD75 OM - Manual (Page 91)

OPERATION
Gleaner R62/R72 Combines
System Requirements (Gleaner R62/R75)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
The following system components are required in order for the Auto Header Height system to work:
• Main module (PCB board) and header driver module (PCB board) mounted in card box in Fuse Panel Module (FP)
• Multi Function Control Handle operator inputs
• Operator inputs mounted in the control console module (CC) panel
NOTE:
In addition to the above components, the electro hydraulic header lift control valve must also be considered
an integral part of the system.
Calibrating the Auto Header Height System (Gleaner R62/R72)
For best performance of the Auto Header Height system, perform these procedures with the center-link adjusted
as long as possible. When setup and calibration is complete, adjust the center-link back to desired header angle.
Refer to “Header Angle” in Operation section of the header operator’s manual.
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To calibrate the auto header height system, follow
these steps:
1. Ensure the center-link is as short as possible, and that
the adapter float is unlocked.
2. Turn on the combine, and then press and hold the
hidden C1 button (A) until the LED light (B) flashes
momentarily.
3. Lower the feeder house as far as it will go.
4. Press and hold the hidden L2 button (C) until the LED
light (B) flashes momentarily. The auto header height
system is now calibrated.
Figure 4.79: Combine Header Control System
Operation Settings (Gleaner R62/R72 Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
169894 77 Revision A