MacDon FD75 OM - Manual (Page 193)

OPERATION
13. The conversion is complete when the wheels are as
shown.
Figure 4.269: Field Position
A - Left Side B - Right Side
4.12.4 Converting from Field to Transport Position
To convert the header from field to transport position, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. Refer to the combine
operator’s manual for instructions regarding the proper use and storage of header safety props.
Moving Front (Left) Wheels into Transport Position
To move the left transport wheels into transport position,
follow these steps.
CAUTION
Stand clear of wheels and release linkage carefully as
wheels will drop once the mechanism is released.
1. Pull handle (B) up to release and raise the linkage (A)
fully upward in the vertical support.
2. Raise header fully, stop engine, and remove key from
ignition. Engage header safety props.
Figure 4.270: Raising Linkage
169894 179 Revision A