MacDon FD75 OM - Manual (Page 201)

OPERATION
4.13 Storage
The following should be done at the end of each operating season:
CAUTION
Never use gasoline, naphtha, or any volatile material for cleaning purposes. These materials may be toxic
or flammable.
CAUTION
Cover cutterbar and knife guards to prevent injury from accidental contact.
1. Clean header thoroughly.
2. Store machine in a dry, protected place if possible. If stored outside, always cover with a waterproof canvas or
other protective material.
NOTE:
If machine is stored outside, remove drapers and store in a dark, dry place. If drapers are not removed,
store header with cutterbar lowered so water/snow will not accumulate on drapers. This accumulation of
weight puts excessive stress on drapers and header.
3. Lower header onto blocks to keep cutterbar off the ground.
4. Lower reel completely. If stored outside, tie reel to frame to prevent rotation caused by wind.
5. Re-paint all worn or chipped painted surfaces to prevent rust.
6. Loosen drive belts.
7. Lubricate header thoroughly, leaving excess grease on fittings to keep moisture out of bearings. Apply grease
to exposed threads, cylinder rods, and sliding surfaces of components. Oil knife components to prevent rust.
8. Check for worn or broken components, and repair or order replacements from your MacDon Dealer. Attention
to these items right away will save time and effort at beginning of next season.
9. Replace or tighten any missing or loose hardware.
169894 187 Revision A