MacDon FD75 OM - Manual (Page 124)

OPERATION
1. Press the top right button (A) once. On the Command
Center, the page will display the current setting.
Figure 4.140: Combine Command Center
2. To adjust rates press the “-” or “+” (A) button to
make a change.
Figure 4.141: Combine Display
Setting Preset Cutting Height (John Deere S Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To operate your Auto Header Height, follow these steps:
1. From the main page of the Command Center, press
the header option button (A).This is the icon with a
header on it. The COMBINE - HEADER SETUP page
displays.
This page is used to set various header
settings such as reel speed, header width, and height
of feeder house for acre counter engagement.
Figure 4.142: Combine Display
169894 110 Revision A