MacDon FD75 OM - Manual (Page 389)

MAINTENANCE AND SERVICING
Removing Plastic Fingers
WARNING
To avoid bodily injury from fall of raised reel, always
engage reel safety props before going under raised
reel for any reason.
1. Remove screw (A) with a Torx
®
Plus 27 IP
socket wrench.
Figure 6.258: Removing Finger
2. Push finger top clip back toward reel tube and remove
from finger tube.
Figure 6.259: Removing Finger
Installing Plastic Fingers
WARNING
To avoid bodily injury from fall of raised reel, always
engage reel safety props before going under raised
reel for any reason.
1. Position finger on rear of finger tube and engage lug at
bottom of finger in lower hole in finger tube.
2. Gently lift top flange and rotate finger until lug in top
flange engages upper hole in finger tube.
Figure 6.260: Installing Finger
169894 375 Revision A