MacDon FD75 OM - Manual (Page 145)

OPERATION
10. Push the GRAPH tab beside the SETTINGS tab to view
the voltage.
Figure 4.187: Combine Display
Configuring Combine (New Holland CR/CX Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To configure the combine, follow these steps:
1. On the combine display screen, select Header lateral
float, and then press ENTER.
2. In the window that opens, select Installed. You
can use the up and down navigation keys to move
between options.
Figure 4.188: Combine Display
3. On the combine display screen, select Header
Autofloat, and then press ENTER.
4. In the window that opens, select Installed.
Figure 4.189: Combine Display
169894 131 Revision A