MacDon FD75 OM - Manual (Page 347)

MAINTENANCE AND SERVICING
6.10.3 Replacing Feed Deflectors
To replace feeder deflectors in New Holland CR model combines, follow these steps:
1. Determine position of existing deflector (A) by
measuring gap (B) between deflector forward edge
and pan.
Figure 6.160: Feed Deflector-End
2. Remove two bolts (B), and nuts securing deflector (A)
to adapter frame, and remove deflector.
3. Position replacement deflector, and secure with
bolts (B) and nuts (nuts toward combine). Maintain
dimension from existing deflector for replacement
deflector.
4. Repeat for opposite deflector.
5. After attaching header to combine, extend center-link
fully, and check gap between deflector and pan.
Maintain 3/4—1 in. (19—25 mm).
Figure 6.161: Feed Deflector
169894 333 Revision A