MacDon FD75 OM - Manual (Page 136)

OPERATION
NOTE:
You can also use button (A) or (B) to set the
fore-aft position of the reel.
8. Press button (C) or button (D) for three seconds to
store the setting into CEBIS.
NOTE:
The alarm will sound when the new
setting is stored.
NOTE:
Whenever button (C) or button (D) is
pressed for three seconds, the current
positions for the following functions are
stored: reel speed and cutting height.
Figure 4.166: Set and Story the Fore-Aft
Position of the Reel
Lexion 700 Series Combines
Calibrating the Auto Header Height System (Lexion 700 Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To calibrate the Auto Header Height System, follow
these steps:
1. To calibrate the Auto Contour, select the icon with the
reel in the header by pushing control knob (A). The
control knob (A) is used to scroll left and right in top
row (B). Once you find symbol you want to work with
push (A) to select this field.
Figure 4.167: Combine Display, Console, and
Propulsion Lever
169894 122 Revision A