MacDon FD75 OM - Manual (Page 359)

MAINTENANCE AND SERVICING
9. Remove bolt (A) that secures the other end of the drive
roller (B) to the support arm.
10. Remove the drive roller (B).
Figure 6.183: Drive Roller
Replacing Side Draper Drive Roller Bearing
1. Remove draper idler roller assembly. Refer to
2. Remove bearing assembly (A) and seal (B) from roller
tube (C) as follows:
a. Attach a slide hammer (D) to threaded shaft (E) in
bearing assembly.
b. Tap out the bearing assembly (A) and seal (B).
3. Clean inside of roller tube (C). Check tube for wear or
damage and replace if necessary.
Figure 6.184: Drive Roller Bearing
169894 345 Revision A