MacDon FD75 OM - Manual (Page 184)

OPERATION
4.11.2 Installing Beater Bars
To install beater bars, follow these steps.
1. Locate one beater bar (B) with one clamp set (C)
on auger tube and loosely secure with carriage
bolt (A) and nut. Bolt head MUST face direction of
auger rotation.
2. Locate remaining clamp sets on tube and loosely
attach to beater bar with carriage bolts and nuts. Bolt
heads MUST face direction of auger rotation.
3. Position second beater bar in clamps and secure with
carriage bolts and nuts.
4. Tighten bolts.
Figure 4.256: Beater Bars
169894 170 Revision A