MacDon FD75 OM - Manual (Page 123)

OPERATION
1. Press button (A) twice. On the Command Center, the
page will display the current setting.
Figure 4.138: Combine Command Center
2. To adjust rates, press the “-”or “+” sign (A) to
make a change.
Figure 4.139: Combine Display
Adjusting the Manual Header Raise/Lower Rate (John Deere S Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To adjust the raise/lower rate, follow these steps:
169894 109 Revision A