MacDon FD75 OM - Manual (Page 173)

OPERATION
1. Using a 3/4 in. wrench, turn the cam latch pin (A)
counterclockwise to release the cam disc.
2. Use the wrench on bolt (B) to rotate cam disc and align
latch pin (A) with desired hole (1 to 4) at (C) in cam disc.
NOTE:
Bolt (B) is through cam disc. Some parts shown
transparent for visibility.
3. Turn latch pin (A) clockwise to engage and lock
cam disc.
4. Repeat above procedure for the other reel.
IMPORTANT:
Secure cam position before operating machine.
Figure 4.239
4.7.12 Crop Dividers
Crop dividers are used to help divide the crop when harvesting. They are removable to allow installation of vertical
knives and to decrease transport width.
Removing Crop Dividers from Header with Latch Option
To remove crop dividers from a header with the latch option, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. Refer to the combine
operator’s manual for instructions regarding the proper use and storage of header safety props.
1. Lower reel, raise header, stop engine, remove key, and engage header safety props. For instructions, refer to
your combine operator’s manual.
2. Open/remove header endshields. Refer to 4.2.3 Endshields, page 35 .
3. Lift safety lever (A).
4. Hold onto divider (B), push lever (C) to open latch and
lower divider.
Figure 4.240: Crop Divider
169894 159 Revision A