MacDon FD75 OM - Manual (Page 139)

OPERATION
2. Hold the left side of the header lift and lower switch (A)
until you hear a ping.
NOTE:
You can set two different cutting heights.
Figure 4.173: Combine Display, Console, and
Propulsion Lever
Adjusting Sensitivity of the Auto Header Height (Lexion 700 Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To adjust the sensitivity of the Auto Header Height, follow these steps:
1. Use control knob (A) to navigate to the header and reel
icon (B) on the CEBIS screen.
2. Push the knob to select this icon. The header/reel
window opens.
Figure 4.174: Combine Display, Console, and
Propulsion Lever
169894 125 Revision A