MacDon FD75 OM - Manual (Page 219)

HEADER ATTACHMENT/DETACHMENT
5.4 Lexion Combines
5.4.1 Attaching Header to Lexion Combine
To attach header to the combine, follow these steps:
Figure 5.36: Attaching Header
1. Move handle (A) on the CA25 adapter into raised
position, and ensure pins (B) at bottom corners of
adapter are retracted.
2. Start engine, and slowly drive combine up to header
until feeder house is directly under the adapter top
cross member.
Figure 5.37: Pins Retracted
3. Raise feeder house to lift header, ensuring feeder
house posts (A) are properly engaged in adapter
frame (B).
4. Position header slightly off the ground.
CAUTION
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
Figure 5.38: Header on Combine
169894 205 Revision A