MacDon FD75 OM - Manual (Page 149)

OPERATION
1. On the combine display screen, select Header
raise rate.
2. Use the “+” or “–“ buttons to change the setting.
3. Press ENTER to save the new setting.
NOTE:
The raise rate can be changed between
32 and 236 in steps of 34. The factory
setting is 100.
Figure 4.194: Combine Display
Setting the Header Lower Rate to 50 (New Holland CR/CX Series)
The fast lower speed (the automatic header height control button or second speed on the header height rocker
switch of the multi-function handle) can be changed.
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To set the header lower rate, follow these steps:
1. On the combine display screen, select Header
lower rate.
2. Use the “+” or “–“ buttons to change the setting to 50.
3. Press ENTER to save the setting.
NOTE:
The setting can be changed between 2
and 247% in steps of 7.
It is factory
set to 100%.
Figure 4.195: Combine Display
Setting the Auto Header Height Sensitivity to 200 (New Holland CR/CX Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
169894 135 Revision A