MacDon FD75 OM User Manual
Page 122
6.
After selecting feeder house speed or header for
calibration, click the arrow inside a box button (A)
on the bottom right corner of the page. The button
turns green.
Figure 4.136: Combine Display
7.
Click the button (A) again. Instructions on the page
will guide you through the steps to complete with
the calibration.
NOTE:
If an error code pops up during the calibration the
sensor is out of voltage range and will require
adjustment. Refer to
from the Combine Cab (John Deere S Series),
page 104
.
Figure 4.137: Combine Display
Increasing the Sensitivity of the Auto Header Height (John Deere S Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To adjust the sensitivity of the Auto Header Height, follow
these steps:
169894
108
Revision A