MacDon FD75 OM - Manual (Page 340)

MAINTENANCE AND SERVICING
Installing Adapter Feed Draper Drive Roller
1. Position roller (C) in adapter frame.
2. Slide motor (B) into the drive roller. Secure the motor
to the feed deck with four bolts (A).
Figure 6.144: Motor
3. Install bearing flangettes (C) and bearing.
4. Install three bolts (B), to secure bearing and flangettes
to the feed deck.
5. Lock bearing collar (A) and tighten setscrew.
6. Install the feed deck draper. Refer to 6.9.1 Replacing
Adapter Feed Draper, page 322 .
7. Tension the feed draper. Refer to 6.9.2 Adjusting Feed
Draper Tension, page 323 .
8. Attach the header to the adapter. Refer to 5.7.2
Attaching Header to Adapter and Combine, page 235
for procedure.
Figure 6.145: Bearing
Replacing Adapter Drive Roller Bearing
Removing Adapter Feed Draper Drive Roller Bearing
1. Remove the header from the adapter. Refer to 5.7.1 Detaching Header from Adapter and Combine, page 230
for procedure.
2. Raise header fully, stop engine, and remove key. Engage header safety props.
169894 326 Revision A