MacDon FD75 OM - Manual (Page 409)

MAINTENANCE AND SERVICING
14. Reinstall linkage cover (A), secure with bolt (B).
Figure 6.303: Linkage Cover
6.14.2 Adjusting Wing Balance
This procedure is used to adjust the wing balance after determining the imbalance in the previous section.
Before proceeding check the wing balance to verify how to
adjust the wing. Refer to
6.14.1 Checking Wing Balance,
page 390 .
NOTE:
Left-hand side is shown.
1. Extend the header center-link to between B and C on
indicator (A).
2. Park combine on level ground and raise header until
cutterbar is 6–10 in. (152–254 mm) off the ground.
3. Stop engine and remove key.
4. If installed, move transport/stabilizer wheels so that
they are supported by header.
Refer to Step 4.7.1
Cutting Height, page 51 .
Figure 6.304: Center Link
5. Remove linkage cover (A) by removing bolt (B).
Figure 6.305: Linkage Cover
169894 395 Revision A