MacDon FD75 OM - Manual (Page 126)

OPERATION
5. Adjustment for selecting the different button settings is
done by control knob (A).
Figure 4.146: Combine Control Console
6. When the header height is engaged, the Auto header
height icon appears on the monitor with the number
from which button is pressed.
Figure 4.147: Combine Display
Lexion 500 Series Combines
Calibrating the Auto Header Height System (Lexion 500 Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To calibrate the Auto Header Height System, follow
these steps:
1. Use the “<“ key or the “>” key to select “Auto header”.
Once selected, press the “OK” key to confirm your
selection. Window (E5) displays whether the automatic
header height is on or off.
169894 112 Revision A