MacDon FD75 OM - Manual (Page 80)

OPERATION
Adjusting the Header Height (AGCO 6 Series)
Once the AHHC is activated, press and release the lower button on the control handle. The AHHC will
automatically lower the header to the selected height setting.
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To selected AHHC height is adjusted using the height
adjustment knob on the control console.
Turning the
knob clockwise increases the selected height and
counterclockwise decreases the selected height.
Figure 4.51: Height Adjustment Knob on the
Combine Control Console
Adjusting the Header Raise/Lower Rate (AGCO 6 Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To adjust the header raise/lower rate, follow these steps:
1. On the FIELD page, press the Header icon. The
HEADER page displays.
Figure 4.52: Combine Display
169894 66 Revision A