MacDon FD75 OM - Manual (Page 310)

MAINTENANCE AND SERVICING
8. Position cover (A) from inside auger over hole, and
secure with screws (B). Coat screws with Loctite
®
#243
(or equivalent), and torque to 75 in·lbf (8.5 N·m).
Figure 6.82: Auger
Installing Feed Auger Tines
1. Remove access cover (if applicable).
2. Insert tine (B) through plastic guide (D) from inside
the auger.
3. Insert tine into bushing (C).
NOTE:
The #6 tine (E) must also be inserted through the
square tube (F).
4. Secure tine (B) in bushing (C) with hairpin (A). Install
hairpin with closed end leading with respect to auger
forward rotation.
Figure 6.83: Installing Tine
A - Hairpin B - Tine
C - Bushing D - Plastic Guide
E.- Tine F - Square Tube
169894 296 Revision A