MacDon FD75 OM - Manual (Page 185)

OPERATION
4.12 Transporting Header
WARNING
Do NOT drive combine with header attached on a road or highway at night, or in conditions which reduce
visibility, such as fog or rain. The width of the header may not be apparent under these conditions.
4.12.1 Transporting Header on Combine
CAUTION
• Check local laws for width regulations and lighting or marking requirements before transporting on
roads.
• Follow all recommended procedures in your combine operator's manual for transporting, towing, etc.
• Disengage header drive clutch when travelling to and from the field.
• Before driving combine on a roadway, be sure flashing amber lamps, red tail lamps and head lamps are
clean and working properly. Pivot amber lamps for best visibility by approaching traffic. Always use
these lamps on roads to provide adequate warning to other vehicles.
• Do NOT use field lamps on roads, they may confuse other drivers.
• Before driving on a roadway, clean slow moving vehicle emblem and reflectors. Adjust rear view mirror
and clean windows.
• Lower the reel fully and raise header unless transporting in hills. Maintain adequate visibility and be
alert for roadside obstructions, oncoming traffic and bridges.
• When travelling downhill, reduce speed and keep header at a minimum height. This provides maximum
stability if forward motion is stopped for any reason. Raise header completely at bottom of grade to
avoid contacting ground.
• Travel speed should be such that complete control and machine stability are maintained at all times.
4.12.2 Towing
The header can be towed behind the combine or with the Slow Speed Transport/Stabilizer Wheel option, or on an
approved header transporter. Refer to your combine operator’s manual, or see your MacDon Dealer.
169894 171 Revision A