O-ring boss (orb) hydraulic fittings (adjustable) – MacDon FD75 OM User Manual
Page 265
O-Ring Boss (ORB) Hydraulic Fittings (Adjustable)
1.
Inspect
O-ring
(A)
and
seat
(B)
for
dirt
or
obvious defects.
2.
Back off the lock nut (C) as far as possible. Ensure that
washer (D) is not loose and is pushed toward the lock
nut (C) as far as possible.
3.
Check that O-ring (A) is NOT on the threads, adjust
if necessary.
4.
Apply hydraulic system oil to the O-ring (A).
Figure 6.11: Hydraulic Fitting
5.
Install fitting (B) into port until back up washer (D) and
O-ring (A) contacts on part face (E).
6.
Position angle fittings by unscrewing no more than
one turn.
7.
Turn lock nut (C) down to washer (D) and tighten to
torque shown. Use two wrenches, one on the fitting (B)
and the other on the lock nut (C).
8.
Check the final condition of the fitting.
Figure 6.12: Hydraulic Fitting
169894
251
Revision A