MacDon FD75 OM - Manual (Page 52)

OPERATION
Installing Endshields
To install an endshield, follow these steps.
1. Position endshield on support (A) and align the hole in
the endshield with stud (B) on the support.
Figure 4.14: Installing Endshield
2. Secure endshield to the support with acorn nut (A).
3. Close endshield. Refer to Closing Endshields, page
36 .
NOTE:
Plastic endshields are subject to expansion,
or contraction depending on large temperature
variations.
Top pin and lower latch bracket
positions can be adjusted to compensate for
dimensional changes.
Refer to Adjusting
Endshields, page 39 .
Figure 4.15: Installing Endshield
169894 38 Revision A