MacDon FD75 OM User Manual
Page 254
27. If quick disconnects are installed, connect as follows:
a.
Remove covers (if installed) from receptacles and
hose ends.
b.
Check connectors, and clean if required.
c.
Push hose connector onto mating receptacle until
collar on receptacle snaps into lock position.
NOTE:
Ensure hoses are clear of driveline and adjacent
structure.
NOTE:
It is not necessary to bleed the system by
loosening fittings.
28. Check float, and confirm that the header is level. Refer
to:
•
Checking and Adjusting Header Float Checking and
Adjusting Header Float, page 138
.
•
4.8 Leveling the Header, page 165
.
29. Start combine and perform the following:
• Raise and lower reel to ensure hoses are properly
connected.
• Run the header to ensure hoses are properly
connected.
30. Check for leaks.
Figure 5.127: Quick Disconnect
169894
240
Revision A