MacDon FD75 OM - Manual (Page 387)

MAINTENANCE AND SERVICING
3. Disconnect connector (A).
Figure 6.253: Sensor Harness
4. Cut cable tie (A) securing harness to cover.
5. Remove screws (B), sensor (C), and harness. Bend
cover (D) (if necessary) to remove harness.
6. Feed wire of new sensor behind cover (D) through
chain case.
7. Locate new sensor in support (E) and attach with two
screws (B).
8. Adjust gap between sensor disc (F) and sensor (C) to
0.02 in. (0.5 mm) by bending support.
Figure 6.254: Support
A - Cable Tie B - Screws C - Sensor
D - Cover E - Support F - Sensor Disc
9. Connect to harness at (A), and secure with cable ties.
Figure 6.255: Sensor Harness
6.12.9 Reel Tines
IMPORTANT:
Keep reel tines in good condition. Straighten or replace as required.
169894 373 Revision A