6header drive, 1removing driveline, Header drive – MacDon FD75 OM User Manual
Page 293: Removing driveline, 6 header drive, 1 removing driveline, Caution
6.6
Header Drive
The header drive consists of a driveline from the combine to the CA25 combine adapter gearbox that drives the feed
auger and a hydraulic pump. The pump provides hydraulic power to the drapers, knife, and optional equipment.
6.6.1
Removing Driveline
To remove the driveline, follow these steps.
NOTE:
The driveline normally remains attached to the adapter, and is stored on the hook provided when not
in use.
CAUTION
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1.
If adapter is attached to combine, remove driveline from combine by pulling the quick disconnect collar to release
driveline yoke at combine shaft.
2.
Remove two nuts (A) attaching shield (B) to gearbox.
3.
Slide shield over poly driveline shield to expose quick
disconnect on gearbox. Do NOT disconnect tether (C).
4.
Pull quick disconnect collar to release driveline yoke,
and pull driveline off shaft.
5.
Slide shield (B) off driveline.
Figure 6.44: Driveline
6.
Rotate disc (A) on adapter driveline storage hook, and
remove the driveline from hook.
Figure 6.45: Driveline
169894
279
Revision A