MacDon FD75 OM - Manual (Page 148)

OPERATION
7. Select the “Maximum Stubble Height”
calibration window.
Message:
“Set header to desired maximum
stubble height”.
Message: “Then press enter”.
Figure 4.192: Calibration Window
8. Put header to the correct position using the header up
or down control switch on the multifunction handle.
9. Press “enter” to continue.
Message: “Calibration successful”.
10. The calibration is done. Press ENTER or ESC to close
the calibration window.
Figure 4.193: Calibration Window
Adjusting Header Raise Rate (New Holland CR/CX Series)
If the header raise rate (the first speed on the header height rocker switch of the multifunctional handle) is not
acceptable, it can be adjusted.
NOTE:
Changes may have been made to the combine controls or display since this document was published.
Refer to the combine operator’s manual for updates.
To adjust the header raise rate, follow these steps:
169894 134 Revision A