Rockwell Automation 8520 9/Series CNC Lathe User Manual
Page 132
Editing Programs On Line
Chapter 5
5-26
SELECT
DRILL
PROMPT
MENU DISPLAY
G80: CANCEL OR END FIXED CYCLE
G81: DRILLING CYCLE, NO DWELL/RAPID OUT
G82: DRILLING CYCLE DWELL/RAPID OUT
G83: DEEP HOLE DRILLING CYCLE
G83.1: DEEP HOLE PECK DRILLING CYCLE, DWELL
G84: RIGHT HAND TAPPING CYCLE
G84.1: LEFT HAND TAPPING CYCLE
G85: BORING CYCLE, NO DWELL/FEED OUT
G86: BORING CYCLE SPINDLE STOP, RAPID OUT
G86.1: BORING CYCLE, SPINDLE SHIFT
G87: BACK BORING CYCLE
G88: BORING CYCLE, SPINDLE STOP/MANUAL OUT
G89: BORING CYCLE, DWELL/FEED OUT
2.
Position the cursor at the desired cycle to prompt by using the up and
down cursor keys. The selected cycle appears in reverse video.
3.
Once you select the correct cycle code, press the
{SELECT}
softkey.
A screen with prompts for that cycle appears along with a graphical
representation of the cycle.
4.
Use the up and down cursor keys to select the parameters to be
changed or entered. The selected parameter appears in reverse video.
Axis words followed by a (1), (2), or (3) are prompting for the first,
second, or third coordinate position respectively. The location of the
first, second, or third axis word appears on the drawing
accompanying the prompt screen.
Prompts that are shown: Indicate that:
in reverse video
this parameter is optional and does not need to be
entered in this block,
with an OR to the left of
the prompt
there are two more optional parameters for this
prompt, only one of which needs a value assigned.
5.
Type in the desired data for that parameter on the input line of the
CRT, and press the
[TRANSMIT]
key.
6.
After you enter all data for the G-code, store the data by pressing the
{STORE}
softkey.