Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 233)

Displays and Graphics
Chapter 8
8-23
If the parameter altered is used in the currently executing program block,
that value will not be activated until the following block (unless a cutter
compensation value is being altered).
If the parameter is altered in a block that is within the controls look ahead
range (refer to chapter 22 for details on block look ahead) then the look
ahead blocks are re-setup and the new parameter value is incorporated in
them (unless a cutter compensation value is being altered).
If a cutter compensation value is being altered the control will not re-setup
any blocks in the block look ahead. If the modified value is currently
active the block look ahead buffer is re-setup with the new offset value. If
the modified value is not currently the active value the control will display
an error message.
The 9/Series control is equipped to display all screens, softkeys, and
messages in multiple languages. Functionality of the 9/240 language
function is somewhat different than other 9/Series controls.
Press the {SWITCH LANG} softkey to access these languages.
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
(softkey level 1)
Each time you press the
{SWITCH LANG}
softkey, the language displayed on
the screen changes. The system installer can password protect this softkey.
9/230, 9/260, and 9/290 CNCs
These control types are capable of displaying two languages. Your system
installer selects the languages and the order in which they are displayed.
Refer to your system installers documentation for details on which
languages your system supports. The default languages are English and
German.
8.3
Changing Languages