Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 153)

Editing Programs On Line
Chapter 5
5-47
To fill in the encryption/decryption table by using the operator panel
keys:
use the arrow keys to move the cursor to the place where you want
to assign an encryption/decryption character
enter a character and press the
[TRANSMIT]
key
You must enter a unique character for each character on the set-up
encryption screen.
To fill in the encryption/decryption table by using the
{REVRSE FILL}
softkey, press the
{REVRSE FILL}
softkey. Pressing
this softkey automatically fills the spaces of the
encryption/decryption table in a reverse order as shown below:
UPDATE
& EXIT
STORE
BACKUP
REVRSE
FILL
ENTER A CHARACTER:
= ] . = Q 9 = F D = ; O = 0 Z = #
” = [ / = P : = E E = : P = / [ = ”
# = Z 0 = O ; = D F = 9 Q = . ] =
% = Y 1 = N < = C G = 8 R = -
& = X 2 = M = = B H = 7 S = ’
( = W 3 = L > = A I = 6 T = +
) = V 4 = K ? = @ J = 5 U = *
* = U 5 = J @ = ? K = 4 V = )
+ = T 6 = I A = > L = 3 W = (
’ = S 7 = H B = = M = 2 X = &
- = R 8 = G C = < N = 1 Y = %
3. Enter the encryption/decryption characters one at a time, press the
{REVRSE FILL}
softkey, or modify the reverse filled screen.
4. Press the
{UPDATE & EXIT}
softkey to update and exit the
encryption/decryption table.
UPDATE
& EXIT
STORE
BACKUP
REVRSE
FILL
(softkey level 3)