Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 352)

Coordinate Control
Chapter 13
13-10
When you enable scaling for a particular axis, the letter “P” is displayed
next to the axis name on all axis position display screens. Figure 13.5
shows scaling enabled on all axes.
Figure 13.5
Axis Position Display Screen Showing Scaling Enabled
E-STOP
PROGRAM[ MM ] F 0.000 MMPM
PR X 1234.567 S 00
P Z 9876.000 T 0
(ACTIVE PROGRAM NAME)
MEMORY MAN STOP
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
The scaling magnification data screen lists for all axes, the:
currently active scaling magnification amount
current center of scaling
default scaling magnification amount
The currently active scaling magnification amount and the current center
of scaling for the axes can only be monitored through this screen. The
default scaling magnification amount for the axes can be monitored or
changed through this screen.
The default scaling magnification values should be changed only when the
control is in a stopped state. If the default values are changed, the new
default values do not become active until the next G14.1 block is executed.
13.5.1
Scaling and Axis Position
Display Screens
13.5.2
Scaling Magnification Data
Screen