Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 152)

Editing Programs On Line
Chapter 5
5-46
To set-up the character encryption/decryption table:
1. Select the protected part program directory.
2. Press the
{SET-UP NCRYPT}
softkey.
REFORM
MEMORY
CHANGE
DIR
NCRYPT
MODE
SET-UP
NCRYPT
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERIFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
The control displays the set-up encryption screen:
UPDATE
& EXIT
STORE
BACKUP
REVRSE
FILL
ENTER A CHARACTER:
= . = 9 = D = O = Z =
= / = : = E = P = [ =
# = 0 = ; = F = Q = ]=
% = 1 = < = G = R =
& = 2 = = = H = S =
( = 3 = > = I = T =
) = 4 = ? = J = U =
* = 5 = @ = K = V =
+ = 6 = A = L = W =
’ = 7 = B = M = X =
- = 8 = C = N = Y =
You must fill in the encryption/decryption table. During the
encryption/decryption process, the control uses this table to guide the
character substitution that provides an encrypted or decrypted part
program. You can fill in this table by using the operator panel keys
or the
{REVRSE FILL}
softkey.