Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 77)

Offset Table and Setup
Chapter 3
3-9
Figure 3.8
Tool Offset Screen s
Tool Wear Table Tool Geometry Table
3. Move the cursor to the offset data to be modified. Use the up, down,
left, or right cursor keys to move the block cursor to the tool offset
data on the current page. Press the
{MORE OFFSET}
softkey to change
pages.
To search all pages for a specific offset number, press the
{SEARCH
NUMBER}
softkey and key in the desired offset number. When you
press the
<TRANSMIT>
key, the control locates the cursor at the offset
number you are searching for. The tool offset data located at the
cursor appears in reverse video.
(softkey level 3)
SEARCH
NUMBER
REPLCE
VALUE
ADD TO
VALUE
ACTIVE
OFFSET
MORE
OFFSET
MEAS-
URE
INCH/
METRIC
RADI/
DIAM
COPY
OFFSET
4. Select data entry type:
Unit selection {INCH/METRIC}
To select units of “mm” or “inch” for the offset data, press the
{INCH/METRIC}
softkey. The units used for the currently selected
offset number change each time the softkey is pressed. When the
units are altered, all data previously entered is converted to the newly
selected units (Inch or Metric) for that offset number.